The MGF Register Forums

Hi can anyone advise how much hydrolastic fluid to put in each side to raise the height approx. 3 cm please

Hi thanks for the reply yes it does have drive so you cant engage a gear with the engine running. With the slave cylinder disconnected at the clevis pin I can move the clutch arm through 20mm. I attempted to bleed the slave cylinder but could not get any fluid through from the bleed nipple there are...

Since the winter my MGF clutch pedal is on the floor, I have read the threads concerning sized cutch release arms. I have discounted the slave cylinder and can move the arm freely over 20mm it does not hover return on its own - is this the issue I presume it should return on its own - there is no fl...

Hi I am looking for a CAT for an 1998 car if anyone has one would prefer a genuine part but may consider a pattern one I am based in Essex - thanks Gary

Hi do you have a tailbox for an early f?

Gary

Hi all these posts seam quite old has anyone used any of these or anyone else recently in the Southend area please

Thanks Gary

Hi Rob that's great mine is broken where the gear lever boot screws are how much do you want please

Gary

Thanks!

Hi am looking for a centre console bezel that the gear lever boot attaches to it also runs around the radio and clock etc - its the earlier rectangle gear lever boot - thanks Gary

Hi are you selling spares from your N reg do you have a centre console for and early car

Regards
Gary

Hi do you have a mgf centre console bezal its the square type gear lever gaiter

Regards Gary