Search found 7 matches
- Sun Sep 24, 2017 1:06 pm
- Forum: Technical - Sponsored by Brown & Gammons
- Topic: ABS controller pinout needed
- Replies: 7
- Views: 2268
Re: ABS controller pinout needed
But can PScan make the ABS go through its operating sequence, I.e power the relay , valves and pump to assist in brake bleeding ?
- Wed Sep 13, 2017 8:51 am
- Forum: Technical - Sponsored by Brown & Gammons
- Topic: ABS warning light
- Replies: 9
- Views: 705
Re: ABS warning light
Hi Talkingcars, I am sure that on the PScan that is the lowest version shown .
The car is at my brother in laws drive in Morden SW London, as the MOT expired so needed a drive to keep it on !
The car is at my brother in laws drive in Morden SW London, as the MOT expired so needed a drive to keep it on !
- Mon Sep 11, 2017 3:41 pm
- Forum: Technical - Sponsored by Brown & Gammons
- Topic: ABS warning light
- Replies: 9
- Views: 705
Re: ABS warning light
The ABS light goes out as long as you select an ABS function on the PScan diagnostic board. Drive with it plugged in it records all the wheel speeds etc. Unplug it or turn the engine off and restart the light comes back on. Interestingly when reading the EPAS with the PScan it records a speed sensor...
- Fri Aug 25, 2017 9:56 pm
- Forum: Technical - Sponsored by Brown & Gammons
- Topic: where to get Hydragas pumped up ????
- Replies: 104
- Views: 76292
Re: where to get Hydragas pumped up ????
Just for info I have a liquid levers hydrolastic pump and I am in SW London
- Mon Jul 31, 2017 7:18 pm
- Forum: Technical - Sponsored by Brown & Gammons
- Topic: ABS warning light
- Replies: 9
- Views: 705
Re: ABS warning light
Hi all, I took he plunge and purchased a pscan unit, did all the necessary and plugged it in and from the menu selected abs and went with 5.0 version, and it records no faults and the abs light goes out, turn off the engine, turn it back on and the abs light comes back on ?
- Sat Jul 22, 2017 12:47 am
- Forum: Technical - Sponsored by Brown & Gammons
- Topic: ABS warning light
- Replies: 9
- Views: 705
Re: ABS warning light
Hi guys, yes I checked the fuse and it is good, thing is it started off as a duff rear offside sensor, which I replaced, the light went out, a few days later back on, so thought sod it I will replace them all with new bolts and sensor holders/pedestals. I did a trial run with the new sensors connote...
- Thu Jul 20, 2017 11:34 pm
- Forum: Technical - Sponsored by Brown & Gammons
- Topic: ABS warning light
- Replies: 9
- Views: 705
ABS warning light
Problem with ABS as warning will not extinguish, I have renewed all the sensors with new ones from Rimmer Bros ! Any ideas ?