Page 63 of 82

Re: what have you done on your mgf today?

Posted: Sun Nov 20, 2016 4:17 pm
by Danny b
Fitted a replacement bonnet in the same colour today as mine had a bad crease in it,also fitted new badges front and rear,new number plates and then gave the car a good claybar and polish with auto finesse products bought at the nec
The car is looking superb,and is booked in to have the ns front wing and door resprayed as it has nasty scratch on that side
The f will then be in near mint condition,I need to find out how to upload pics on this site!

Re: what have you done on your mgf today?

Posted: Wed Nov 30, 2016 4:37 pm
by daz
fitted some new washer jets, made a hell of a difference, these if anyone's interested

http://www.ebay.co.uk/itm/331793460647? ... EBIDX%3AIT

Re: what have you done on your mgf today?

Posted: Wed Nov 30, 2016 5:02 pm
by Mikeadman
Ordered Daz hope it didn't wear you out!! :lol: :lol: :lol:

Cheers

Mike

Re: what have you done on your mgf today?

Posted: Wed Nov 30, 2016 5:18 pm
by daz
had to have a little lie down & coffee afterwards :)

Re: what have you done on your mgf today?

Posted: Wed Nov 30, 2016 7:05 pm
by cococola
Just ordered some Daz....be rude not to :lol:

Re: what have you done on your mgf today?

Posted: Thu Dec 01, 2016 1:14 pm
by RSR92
I'm about to order some as well! Job for this weekend however is Coolant temp sensor and replacing the heavy carpet with some (frugal as I am) dense 1 inch thick sofa foam, which looks like it should do perfectly although not sure how great it is going to be sound protection wise...either way it's going to may engine bay access so much easier that removing that awful rug every time which in my eyes is the most effort filled part!

Re: what have you done on your mgf today?

Posted: Sun Dec 11, 2016 5:37 pm
by c13amb
Actually got round to fitting my Satur hoops at last! ! It was against the weather and just managed it before it was too bad!! Took about 2 1/2 hours in total.I wanted a set for years...chuffed to bits with the results!! :thumbsu:
20161211_123427.jpg
20161211_123340.jpg

Re: what have you done on your mgf today?

Posted: Fri Dec 16, 2016 9:02 pm
by daz
This week I have been mainly painting.

Wheels:
20161211_130202.jpg
inner arches:
20161214_162844.jpg
suspension & sub frames:
20161214_162915.jpg
20161214_162929.jpg
& underneath:
20161214_162909.jpg

Re: what have you done on your mgf today?

Posted: Fri Dec 16, 2016 9:22 pm
by cococola
Looking great Daz :thumbsu:

Re: what have you done on your mgf today?

Posted: Tue Dec 20, 2016 9:44 am
by RSR92
Replaced my door speakers as one of the Kenwoods had errr, given up on life, as pictured below

I used the Vibe 6.5" replacements at 11.99 each from Halfords. As the previous owner had fitted these kenwoods no further drilling was required - otherwise 2/3 holes would be necessary to fit the replacements if you were upgrading from stock

Re: what have you done on your mgf today?

Posted: Tue Dec 20, 2016 10:46 am
by daz
Fitted the wheels I've painted, it's sitting a bit high after being on axel stands for 6 weeks :)
20161220_102325.jpg
fitted new lights & exhaust
20161220_102246.jpg
20161219_185112.jpg
& painted the door cappings
20161220_102343.jpg

Re: what have you done on your mgf today?

Posted: Tue Dec 20, 2016 11:05 am
by RSR92
Nice Daz - will be doing my interior purple for my black MGF, it's currently cream leather interior which I intend to swap out for black cloth!

Re: what have you done on your mgf today?

Posted: Tue Dec 20, 2016 12:57 pm
by Helsbyman
Took her out for an Italian tune up. 20mls run which includes a 1.1 ml up a steep hill run @5000 rpm

Re: what have you done on your mgf today?

Posted: Wed Dec 21, 2016 9:40 am
by RSR92
With the speakers sorted I decided it was time to copy a mod I've seen elsewhere and wrap my airbox in some heat reflective tape!

I also managed to reposition the intake hose nearest the front of the car while the airbox was out to draw air from below the car rather than from in the engine bay.

I measured the outside diameter of the other pipe and found it to be 56mm so I'll find some suitable ducting and direct it to the N/s vent

As a result my intake temps are now around 45 C standing and 42-44 while moving. The car pulls a lot better low down, by which I mean smoother acceleration and less jerkiness. My intake temps were just over 50 C before so I'm hoping once the other pipe is directed towards cooler air that I can get intake temps with a warm engine below the 40 C threshold which would be fabulous

Pics of box and what I've done to the hose attached

Re: what have you done on your mgf today?

Posted: Wed Dec 21, 2016 8:59 pm
by Mikeadman
daz wrote:Fitted the wheels I've painted, it's sitting a bit high after being on axel stands for 6 weeks :)
20161220_102325.jpg
fitted new lights & exhaust
20161220_102246.jpg
20161219_185112.jpg
& painted the door cappings
20161220_102343.jpg

Cracking job Daz looking amazing

Cheers

Mike

Re: what have you done on your mgf today?

Posted: Thu Dec 22, 2016 12:18 am
by nickmitchell38
Removed the power unit to replace clutch and only one snapped bolt. While it's out I'm going to upgrade the clutch arm, change the belts etc.

Re: what have you done on your mgf today?

Posted: Fri Dec 30, 2016 11:04 pm
by Heironymous
Well I was chuffed that I replaced my split rear window with a glass one. Looks great and only took me 30 minutes. Just got back from a 400 mile round trip to Scunthorpe and my 2001 MGF 1.8 performed perfectly. The more I drive this car the more I love it. :D

Re: what have you done on your mgf today?

Posted: Mon Jan 02, 2017 9:12 pm
by nigelandjo
Washed and polished and started putting the new stripes on, having removed the worn stripes over the previous few weeks.
Elkie#1.jpg
Elkie#2.jpg

Re: what have you done on your mgf today?

Posted: Sun Jan 15, 2017 8:20 pm
by X10GWR
Replaced the offside rear brake caliper and carrier which had been giving various problems since I had the car. First time I had bled the brakes on a car.

Lot more feel to the brakes now.

Re: what have you done on your mgf today?

Posted: Sun Jan 15, 2017 9:28 pm
by hammond
Had the hydrogas pumped up so can finally fit my hand between the top of the wheel and the arch :lol:

Also fitted some nice chrome Mike Satur pedals :thumbsu: