The MGF Register Forums

Hydragas units removed and Suplex kit installed on my MGF VVC 1997 (89000 miles) and have done 600 miles since. All knuckle joints changed at same time. Both rear ones had plastic locating/seat broken. Also removed 16 inch wheels and fitted original 15 inch and tyre pressures set at 24psi front and 30psi rear. 4 wheel alignment done after install. Significant improvement in ride. Am now looking at installing a Vehicle Handling Solutions torsional kit. Have looked on ebay but nothing there. Anyone on here know of one that may be available?

You could ask one of the breakers if they have one from a TF, where they were fitted as standard.

Have a look at mike satur for anti roll bars

Did VHS beef up the anti roll bars?

Were they bigger on the TF?

The 85th edition had the vhs anti roll bar kit didn't it?

I thought this was about the torsional stiffness kit (as described here on Rob’s site), not the arb?

Mykel wrote:I thought this was about the torsional stiffness kit <<snip>> not the arb?

No, it's about VHS.

http://www.vehiclehandlingsolutions.com/road_cars.htm - the brace kit and subframe mounts are the same as fitted by MG to the TF.

Have eventually contacted Andy Kitson at VHS and ordered bracing and sub frame mounts kits for delivery this week. Thank you for the responses.

VHS do the bracing kits and they do the 85LE upgraded front ARB and double shear mounted drop links as a kit

Early TF front ARBs are a direct swap for the MGF. At the rear is another story...