Hi first I'd like to say nice forum Only just got used to the old one as being a bit new to all this, but I am sure I will get this one sussed too.
My MK1 F has disintegrating door pods, the fabric has come unattached and leaking sandy looking foam everywhere
Is there a way to remove the pods and recover or reglue the original fabric or do I have to get the whole door cards Any suggestions would be must appreciated.
Door Cards
Moderator: Committee Members
Forum rules
Not many rules really, this board being aimed at technical issues, it shouldn't fall foul (hopefully) of some of the more personal issues that can affect forums.
Rule 1 - Is that you need to think very carefully before posting anything technical or asking anything technical relating to the security system of the car - See 'Security Issues' sticky for more info.
Rule 2 - We (MGF Register) do not support copyright infringement and therefore references to CD ROM, PDF versions or paper copies of the workshop manual (for instance) should not be posted on the forum. We don't want to get into trouble and we'd rather sell you a genuine hard copy through our Regalia shop anyway!
Because advice is honestly and freely given in this technical section, much of it will be amateur experienced based, so any information is given in good faith and is not guaranteed as correct.
Not many rules really, this board being aimed at technical issues, it shouldn't fall foul (hopefully) of some of the more personal issues that can affect forums.
Rule 1 - Is that you need to think very carefully before posting anything technical or asking anything technical relating to the security system of the car - See 'Security Issues' sticky for more info.
Rule 2 - We (MGF Register) do not support copyright infringement and therefore references to CD ROM, PDF versions or paper copies of the workshop manual (for instance) should not be posted on the forum. We don't want to get into trouble and we'd rather sell you a genuine hard copy through our Regalia shop anyway!
Because advice is honestly and freely given in this technical section, much of it will be amateur experienced based, so any information is given in good faith and is not guaranteed as correct.
- Lisa Jayne
- Posts: 85
- Joined: Mon Oct 08, 2007 4:14 pm
- MGF Register Region: South East
- Location: Kent
Door Cards
Last edited by Lisa Jayne on Thu Oct 11, 2007 9:13 am, edited 1 time in total.
Emy - 1998 1.8 Flame Red MGF
-
- Posts: 7
- Joined: Mon Oct 08, 2007 2:35 pm
- MGF Register Region: Yorkshire
- Model of Car: MY04 TF
- Location: Yorkshire
Re: Door Cards
http://www.mgf-tf-central.co.uk/scarlet ... _cards.htm
This will tell you how to remove the door card, you can then remove the bit of trim you mention, from behind, quite easily.
Hope this helps,
Iain
This will tell you how to remove the door card, you can then remove the bit of trim you mention, from behind, quite easily.
Hope this helps,
Iain
- Lisa Jayne
- Posts: 85
- Joined: Mon Oct 08, 2007 4:14 pm
- MGF Register Region: South East
- Location: Kent
Re: Door Cards
Thanks for you help, I think I will save that job for when I am renewing my window stops, and adding some bling to the door locks.
Get it all done in one go and only break my nails once!
Get it all done in one go and only break my nails once!
Emy - 1998 1.8 Flame Red MGF
- Rob Bell
- Committee Member
- Posts: 14425
- Joined: Tue Oct 02, 2007 2:36 pm
- MGF Register Region: South East
- Model of Car: MGF 1.8i + MGF Shed!
Re: Door Cards
Hi Lisa,
This may help too: http://www.mgf.ultimatemg.com/group2/DI ... /index.htm - these are Gareth Hampson's instructions on how to change that door trim pod on a Mk1 to accept a later Mk2/ TF door pod. Thankfully, it looks pretty simple, and in fact should give a better end result than attempting to recover the trim on a DIY basis
This may help too: http://www.mgf.ultimatemg.com/group2/DI ... /index.htm - these are Gareth Hampson's instructions on how to change that door trim pod on a Mk1 to accept a later Mk2/ TF door pod. Thankfully, it looks pretty simple, and in fact should give a better end result than attempting to recover the trim on a DIY basis