FS: Brand new Trophy 160 Splitter in primer (boxed)

[bgunn]

I have one of these for sale as I no longer have my MG F. It's boxed, and brand new, and has the adhesive tape all ready to put on.

£100 - which is what I paid for it (I also paid postage on top, so I'm actually losing out), PLUS a free MGF bumper that's partially rubbed back to the plastic ready for repainting.

Collection preferable as the box it's in is huge and it'd cost a fortune to post - plus the bumper would be a real pain to post without damage, from NW London.

Brian.

[GazMG]

What's the lowest you'd accept for this? I only need the splitter, not the bumper. They are available for £80 new on the internet - a replacement, not the original, but doesn't matter as a bodyshop would be fitting this.

[bgunn]

I'd like as close as possible to this really, the aftermarket fibreglass copies really aren't very good at all - I checked them out before buying this, so I know you'll spend more than 20 quid on rectification by a bodyshop!

Regards,

Brian.

[GazMG]

OK mate no worries.

I'll take my chances with the aftermarket copy!

[bgunn]

Fair enough, good luck!

[bgunn]

Bumpety bump..

[Rob Bell]

Brian, do you still have the KV6 engine and subframe? I totally dropped that ball, sorry about that - and if it's gone elsewhere to a good home, no worries!

BTW folks, I've seen the bumper. It's in stripped, bare black plastic, but otherwise is intact - perfect for re-spraying actually!

[bgunn]

Rob, It's still available, so if you're interested, it's there! PM me if you're still interested..

Thanks for the bump

[bgunn]

Prepared to take a *sensible* offer on this.

[GazMG]

What's the lowest you'd go for this?

[bgunn]

What are you prepared to offer - we'll see if we can come to an arrangement..

[ElectroSoldier]

Sounds very interesting for a oner...

Can you post a photo or email me please

[bgunn]

PM me your email address and I'll get a pic to you tomorrow..

[bgunn]

Back for a bumpety bump..

[GazMG]

Still interested but wouldn't be able to afford it until early May, I'm sure this is too late?

Depends on price but as mentioned previously, only interested in the splitter itself, provided it has no cutouts for the fogs.

[bgunn]

If it's not sold by then, then it's not too late...

[GazMG]

Thanks, will keep an eye on this then.

[bgunn]

Cool, let me know when you're ready..

[bgunn]

OK, Gary couldn't buy this in the end, so it's up for sale again.

£85 collected.

[pipster101]

Where in the South East are you? I would be interested as I'm after one...Please PM me if it's still for sale.

Cheers