The MGF Register Forums

Pics

I did 2 hard top linings and did it in bands as you suggested. I used high temp spray adhesive on both surfaces and used a roller to press it down. Very pleased with the results. Don’t forget to overlap around the edges then cut back for the fasteners.

Hi, I’ve done the same. The SRS connectors under the seat are different and easily swapped for a none OEM 2 point connector. The bolts and mountings are the same. Seat belts also compatible in my experience. Good luck.

There’s a few on eBay for example I’m selling some titled ‘MGTF Grey Alcantara & Leather Seats for MGF or MGTF. Good Clean Usable Condition’ on eBay at the moment £89.95 (collection from E Midlands)
Regards
Steve

If you’re in the Midlands, I would recommend MG Obsession.

Just replaced all the upper ball joints, front and back and it’s made a positive difference to the handling of my TF.

Have you tried jacking up each corner and seeing if there’s any play in the geometry/ bushes/bearings MOT style - hold wheel at 3 & 9 o clock then 12 & 6 o block and move back and forward checking for movement.

Have you tried Rimmer Bros?

Pricey one on eBay:
https://www.ebay.co.uk/itm/285644185080 ... media=COPY

PS I’ve got a snapped spade terminal on the silver one. I too have bought conductive glue but waiting for the weather to warm before I have a go at it.

I’m for Xpower grey as well.
Goes really well with your silver TF. I’ve got the same colour TF and have a black and a silver HT but prefer the black. The paint on top of the black one was not great so I stuck a matt black Union Jack on it

Thanks Reckless. Just trying to find bargains for you F owners

My French isn’t great Could this be the one?
https://www.ebay.co.uk/itm/134776977185 ... media=COPY

Or just buy the bezel and upgrade the mesh to the TF version of these
https://www.ebay.co.uk/itm/175774871329 ... media=COPY

Photo?

I fitted my own - took a couple of hours. Tools needed are a drill, suitable sized drill bit to drill out old pop rivets and pop riveter to fit new rivets through the same holes. Look at the condition of the rubber seal along the bottom edge of the hood. I replaced mine at the same time using a neop...

…. very straight forward to fit too….

BAS also sell the replacement glass section which zips in at the top and is secured by replacement pop rivets along the bottom. I’ve got one on my TF - can recommend.

Saw this on the mg-Rover forum with a follow up question: Since MG-Rover were too tight to put a bonnet light in my TF, decided to fit my own....at least they still left a hole in the bonnet skeleton to allow me to fit one! And I am quite happy with the wiring, it went in ok and looks alright too. I...

This comes highly recommended by many MGF / MGTF owners including myself.